Table of Contents
Advertisement
Introduction
- Connect battery to the connector.
- Replace the battery cover.
▶
Connect the AC power supply cable to the DC
input port located at the side of the terminal.
" " R R e e f f e e r r t t o o c c o o n n n n e e c c t t i i o o n n D D i i a a g g r r a a m m w w i i t t h h
e e x x t t e e r r n n a a l l e e q q u u i i p p m m e e n n t t i i n n F F i i g g u u r r e e 2 2 " "
STEP IV. Check LED Indicators
▶
When you followed the installation instruction STEP
I to STEP III, please check the LEDs for normal
operation.
▶
When DC power is fed at the first time, LEDs will
operate as follows:
After few seconds, Power LED is GREEN, if AC/DC
power is applied.
If receiving signal strength is strong enough, then
SIGNAL LED is GREEN.
If not, it is ORANGE or RED. And MODE LED is
turned off.
14
< Figure2. Connection Diagram with External Equipment >
Note:
- Length between LST-270T and Telephone : over 1m.
. . T T h h e e a a d d a a p p t t e e r r t t y y p p e e ( ( w w i i t t h h p p o o w w e e r r c c o o r r d d ) ) m m a a y y b b e e d d i i f f f f e e r r e e n n t t f f r r o o m m c c o o u u n n t t r r y y t t o o c c o o u u n n t t r r y y . .
! Connection telephone jack to data port will cause malfunction of data service
Battery Switch
Introduction
LST-270T
Notice
Before using the terminal, please check
battery switch is on.
After switching on it, use the phone. When charging
the battery, check that battery switch is "on".
15
Advertisement
Table of Contents
