Leds Indicators; Installation - LG LST-270T User Manual

Introduction

2.3 3 LEDs Indicators

L L E E D D
GREEN-solid
SIGNAL LED ORANGE-solid
GREEN - blink
MODE LED
(0.5sec On / 0.5sec Off)
GREEN-solid
POWER LED
ORANGE-solid
12
C C O O L L O O R R O O p p e e r r a a t t i i n n g g C C o o n n d d i i t t i i o o n n
Good Signal
Poor Signal
RED-solid No Service Area
Voice Message is received
DC Power is applied
RED-solid Battery Power is applied
Low Battery
< Table 1 >

2.4 Installation

You should follow each step carefully as shown below
in order to guarantee proper operation of CDMA
Fixed Wireless Telephone.
STEP I. Check Components
▶
Fixed Wireless Terminal is supplied with the
following standard unit and accessories:
1. LST-270T Unit -1EA-
2. Dipole Antenna -1EA-
3. Backup Battery -1EA-
4. User Guide -1EA-
5. AC/DC Power Adapter -1EA-
▶
Please make sure that these components are
present and check for evidence of shipping before
you begin the unit installation.
▶
If components are missing or damage is found,
contact your authorized LGE Service Center
immediately.
Introduction
STEP II. Place the Terminal
▶
Place the terminal on the stable flat secure surface
area (desk, table, etc.).
Avoid direct exposure to the sunlight and damp
areas.
▶
Read the SAFETY INFORMATION located at the
first part of this document before you place the
terminal.
STEP III. Connect Components
▶
Connect the Dipole antenna to the TNC connector
located at the topside of the terminal. (See Figure 1
to locate the TNC connector.)
If you have placed the terminal on the flat surface,
position the antenna up side.
▶
Connect your phone cord to the RJ-11 port located
at the side of the terminal.
▶
Connect the battery cable to the DC battery
connector at the side of the terminal.
- Remove the battery compartment cover.
13