Huawei SmartLogger2000 Quick Manual page 19

1. Prepare a cable with an appropriate length, strip a part of the insulation layer, and connect the
stripped cable core to the ripple control receiver.
2. Strip 8 mm of the insulation layer at the other
end.
3. Remove the terminal block from the
SmartLogger DI port.
NOTE
Remove the terminal block using a flat-head
screwdriver.
9
Connecting Network Cables to the Ethernet Electrical Port
NOTE
1. The SmartLogger provides two Ethernet electrical ports, through which the SmartLogger can
connect to a third-party device.
2. The SmartLogger can be connected to an Ethernet LAN switch, router, or POE device, and then
connected to a PC. It can also be directly connected to a PC. Select the connection device
based on the actual networking scenario.
3. If the cable between the SmartLogger and the PC over the devices such as a POE is routed
outdoors, connect a POE SPD to the POE to enhance the surge protection function. Connect
the POE port on the POE to the PROTECT port on the POE SPD.
4. Verify that the Ethernet communications cable is no longer than 100 m.
1. Connect one end of the delivered network cable to the Ethernet electrical port of a device.
2. Connect the other end of the network cable to the ETH1 or ETH2 port of the SmartLogger.
4. Connect the stripped cable core to the
terminal block of the DI port on the
SmartLogger.
5. Insert the terminal block into the
SmartLogger DI port.
18