Verifying The Installation - Huawei SmartLogger2000 Quick Manual

10
Connecting Optical Fibers to the Ethernet Optical Port
NOTE
The SmartLogger can be connected to devices such as an ATB through optical fibers. You can
select the devices to be connected based on the actual networking scenario.
1. Insert the optical module into the SFP1 or SFP2 port of the SmartLogger.
2. Connect the two cables delivered with the optical module to the ports on the optical module.
3. Connect the other ends of the cables to the ports of the device on the other side (such as an
ATB).
11

Verifying the Installation

No. Check Item
1 The SmartLogger is properly installed.
All cables are properly connected, without open circuits or short
2
circuits.
19
Check Result
□ Passed □ Failed
□ Passed □ Failed