Battery Check - ABB EXCOUNT-II User Manual

Transceiver menu system
0 %
10
1.1.1 Data transfer from PC to
Transceiver
In this mode, Sensor ID's can be transfered from the
PC to the transceiver. Connect the data cable to the
PC serial port. PC Serial port Com 1 is selected as
default by the software.
See also the software help instructions.
Back to transfer data menu
1.1.2 Data transfer from
Transceiver to PC
In this mode data collected from the Sensors can be
transmitted to the PC. Connect the data cable to the
PC serial port. PC Serial port Com 1 is selected as
default.
See also the software help instructions.
Back to transfer data menu

1.2 Battery check

Displays the condition of the battery. Always check the
condition of the battery before transfering data to/from
the transceiver. Change battery if necessary.
If the battery expires during a measurement
100%
session,data can be corrupted or lost.
In such case download the sensor ID's again and
take new readings.
NOTE! Whenever the battery is replaced the transcei-
ver clock and date must be reset. (see 1.4)
Back to main menu
2501en EXCOUNT-II Users Manual