Flowchart, Make Measurements - ABB EXCOUNT-II User Manual

1. Prepare the transceiver
for measurements
See 1.1.1
Set the transceiver to
"Prepare the transceiver
for measurements" mode.
Connect the
transceiver to the PC
via the data cable.
Open the EXCOUNT-II PC-
software and select "Transfer
data" followed by "Prepare
transceiver for measurement".
Select which Sensors are to
be read by station, position
and phase.
Click "Send list to
transceiver" when ready.
This erases all stored
data in the transceiver.
Before going to the site
check the battery status.
See 1.2.
Then turn off the transceiver
to save the batteries.

Flowchart, make measurements

Press to turn
on the transceiver
The main menu is
accessed by pressing
enter
2. Make measurements
See 1.3
Ensure the sensor to be read
is within the range for
transmission (normally
up to 60 m).
Set the transceiver to "Make
measurements" mode.
Select type of measurement by
following the instructions in 1.3.
Select Sensor ID from
the menu in the transceiver
and press enter.
Different types of
measurements can be
performed by following
the instructions in 1.3.
2501en EXCOUNT-II Users Manual
3. Transmit data to the
EXCOUNT-II software
See 1.1.2
Set the transceiver to
"Data transfer from Transceiver
to PC" mode.
Connect the transceiver to
the PC via the data cable
Open the EXCOUNT-II
PC software and select "Transfer
data" followed by
"Receive measured data
from transceiver".
Click "Request data"
when ready.
Click "save" to store the
details in the database.
7