Assigning Ip Address With Arp Command - Philips NetCam 4 Installation Instructions Manual

NetCam_ii_99011_0047.qxd
NetCam4
2.5

Assigning IP Address with ARP command

If you fail to assign an IP address with the setup program, carry out the process
with ARP command.
NetCam4 IP address = IP address to be assigned to the NetCam4.
NetCam4 Ethernet address = MAC printed on the bottom of the NetCam4.
My PC IP address = IP address of the Network Interface Card in your PC>
Note: The NetCam4 and PC IP addresses must be within the same IP address
class.
1. Using ARP in Windows 98 and NT
Start a DOS window and type the following commands.
I
arp -s <NetCam4 IP address> <NetCam4 _________ address>
ping -t <NetCam4 IP address>
Example
I
arp -s 200.243.232.178 00-40-8c-10-00-86
ping -t 200.243.232.178
2. Using ARP in Windows 95
Start a DOS window and type the following commands.
I
arp -s <NetCam4 IP add.> <NetCam4 Ethernet add.> <my PC IP add.>
ping <NetCam4 IP address>
Example
I
arp -s 200.243.232.178 00-40-8c-10-00-86 200.243.232.130
ping 200.243.232.178
14
12/13/00 1:55 PM Page 14
Section 2