Table of Contents
Advertisement
NetCam_ii_99011_0047.qxd
NetCam4
3
ACCESSING NETCAM4 HOMEPAGE & MONITORING
REAL-TIME IMAGE
You can access the NetCam4's own web pages through any standard Web
browser.
3.1
Starting Web browser
http://<NetCam4 IP address>/
Start your web browser and enter your NetCam4 IP address.
I
http://200.243.232.178/
Example
NetCam4 simultaneously supports up to 100 users. Any additional user will
receive the message 'Server is full'.
3.2
Installing NetCam4 Plug-in*
Netscape User: To see the image transferred from NetCam4, initially install the
NetCam4 Plug-in. When you connect the NetCam4 for the first time or
you have an old Plug-in version, you have to download it. In the Plug-in
Download screen click 'Download Plug In' Then you click 'Grant' and
'Install' buttons respectively when prompted. The Plug-in Download screen
is accessible from the various viewers and log-in screens.
MS Explorer User: For a MS Explorer User, Active-X Control is prepared. It will
be installed as soon as you connect to NetCam4. For Active-X installation
on your PC, just click 'Yes' to the question. If you cannot see the images,
you should check if Active-X Control file is installed correctly, located in the
C:\Windows\Download Program Files. If the NetCam4 Control file is not
installed, carry out the installation procedure again. If the file is already
installed but image is not seen, remove the file and re-install it.
*
The plug-in and active-X are licenced by WebGate Inc. and approved by
Verisign.
16
12/13/00
1:55 PM
Page 16
Section 3
Advertisement
Table of Contents
