Table of Contents
Advertisement
NetCam_ii_99011_0047.qxd
NetCam4
3. Verifying installation
After completion, the following message (or similar) will be displayed after the
ping command:
Request timed out
:
Request timed out
Reply from 200.243.232.178: bytes=32 time=2ms TTL=255
Reply from 200.243.232.178: bytes=32 time=2ms TTL=255
Ping statistics for 200.243.232.178:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milliseconds:
Minimum = 1ms, Maximum = 2ms, Average = 1ms
If you cannot receive the reply by the 'ping' command, try again by pressing
I
'F3' and 'Enter' keys again. Normally 'Request timed out' messages appear 7
times before you receive proper reply.
If you succeed in utilizing the above commands, you will receive a
I
continuous connection. Stop the process by pressing <Ctrl>+<C> keys.
If the statistic shows '100% loss', you should check that the network line
I
and connection status are stable; the IP address which is assigned to
NetCam4; and whether a PC has the same local IP address as the NetCam4.
(Same local IP address of C grade network means that the first 3 numbers
are same but the fourth is different. For example 203.243.232.111 and
203.243.232.112 are the same local network IP addresses).
12/13/00
1:55 PM
Page 15
Section 2
15
Advertisement
Table of Contents
