ABB MagMaster User Manual
Electromagnetic flowmeters
Hide thumbs
Also See for MagMaster:
- Instruction manual (32 pages) ,
- Configuration manual (28 pages) ,
- Quick reference manual (2 pages)
Related Manuals for ABB MagMaster
Summary of Contents for ABB MagMaster
- Page 1 User guide IM/MM-BK1 Rev. K MagMaster Electromagnetic flowmeters BOOK 1 Hazardous area approved flowmeters...
- Page 2 Cert. No. Q 05907 applications. EN 29001 (ISO 9001) As a part of ABB, a world leader in process automation technology, we offer customers application expertise, service and support worldwide. We are committed to teamwork, high quality manufacturing, advanced technology and unrivalled service and support.
-
Page 3: Table Of Contents
Considerations ...... 7 2.2.4 Potting ........7 2.2.5 General ........8 2.2.6 MagMaster Sensor Temperature Limits ....8 Warning. • EXPLOSION HAZARD. SUBSTITUTION OF COMPONENTS MAY IMPAIR SUITABILITY FOR CLASS Ι, DIVISION 2. • EXPLOSION HAZARD. DO NOT REMOVE FUSE OR DISCONNECT POWER LEADS WHILE CIRCUIT IS LIVE. -
Page 4: Versions Flowmeters
• The ultimate responsibility for the safety of any installation lies with the installing user/contractor. 1.1 Introduction The range of hazardous area approved MagMaster Flowmeters available are listed in Table 1.1. Identification and their use is shown on a certification label, found on the side of the Sensor Termination Box. -
Page 5: Description
Sensor and the Transmitter must only be that The approval is valid for the following countries: supplied for the purpose by ABB. Other types of cable may not be substituted, even for part runs. Austria, Belgium, Denmark, Finland, France,... -
Page 6: Sensor Box Wiring
…1 CENELEC/ATEX APPROVED FLOWMETERS ...1.4 Installation 1.5 Safety of Pressurised Flowlines – The approval permits If the flowmeter is to operate at significantly more Environmental Protection installation below ground level where provision has than one bar, see the following EECS Newsletter been made to prevent flooding. - Page 7 1 CENELEC/ATEX APPROVED FLOWMETERS... EXTRACT FROM EECS NEWSLETTER We have discussed this recommendation with the NUMBER 15 (OCTOBER 1991) BASEEFA Advisory Council who have agreed that, if satisfactory measures to prevent the occurrence of voids cannot be taken, we should advise Certification of intrinsically safe apparatus for use applicants of the limitations of certification of at non-atmospheric pressure.
-
Page 8: Ce Declaration Of Conformity
…1 CENELEC/ATEX APPROVED FLOWMETERS 1.6 CE Declaration of Conformity... -
Page 9: Fm Approved/Csa Certified Flowmeters
Transmitter must only be that supplied for the Identification and use is shown on certification purpose by ABB. Other types of cable may not be labels – on the side of the terminal box on remote substituted, even for part runs. Where joints between cables have to be made (e.g. -
Page 10: General
Local and National requirements may also preclude some of the above methods. 2.2.6 MagMaster Sensor Temperature Limits Table 2.1 Temperature Limits Standard temperature versions – Maximum process and ambient temperatures in °C. Std. - Page 11 2 FM APPROVED/CSA CERTIFIED FLOWMETERS Sensor CLASS I, DIV 2 GROUPS A,B,C,D Electrodes are intrinsically safe Enclosure 6P c i t o i t ABB Limited Stonehouse, Glos. e r i APPROVED England GL10 3TA a t i Made in England...
- Page 12 NOTES...
- Page 13 NOTES...
- Page 14 ...NOTES...
- Page 15 Repair Centre. — Metals and Minerals — Oil, Gas & Petrochemical — Pulp and Paper ABB Limited Tel: +44 (0)1453 826661 Drives and Motors Fax: +44 (0)1453 829671 — AC and 6 Drives, AC and DC Machines, AC Motors to —...
- Page 16 With regard Stonehouse to purchase orders, the agreed particulars Gloucestershire GL10 3TA shall prevail. ABB does not accept any responsibility whatsoever for potential errors or possible lack of information in this Tel: +44 1453 826 661 document.