Selecting The Dme Wipe Pattern - Sony MVS-6520 User Manual

Selecting the DME Wipe Pattern

The operation of selecting the DME wipe pattern in the
Flexi Pad is the same as the operation of selecting a wipe
pattern (1 p. 108), except for pressing the [DME WIPE]
button to select DME wipe snapshot mode.
Note, however, that the pattern numbers for DME wipe
patterns have four digits
Editing the DME Wipe Pattern
By pressing the [EDIT ENBL] button to switch the
memory recall section to editing mode, you can edit the
selected DME wipe pattern.
To exit from the editing mode, press the [EDIT ENBL]
button again, or press the [EXIT] button.
The operation of the following buttons is the same as when
editing a wipe pattern.
• [EXIT] button
• [PTN LIMT], [LIMT SET] buttons
• [NORM], [NORM/REV], [REV] buttons
• [KNOB 1/2] button
For details about each button operation,
Wipe Pattern" (p.
109).
Channel selection buttons
1ST CH (channel 1): Selects channel 1.
2ND CH (channel 2): Selects channel 2.
124
DME Wipe Pattern Operations in the Flexi Pad
(1 p. 381).
1 "Editing the
You can also select two channels by pressing the buttons
simultaneously.
Notes
The [2ND CH] button cannot be selected on the MVS-
3000.
DME wipe pattern edge setting buttons
BDR (border): Applies a border to the DME wipe pattern.
SOFT BDR (soft border): Softens the applied border.
You can adjust the parameters selected with these buttons
using the adjustment knobs, when the button is lit green.
When border is selected
No. Parameter Adjustment
1 W Border width
2 L Luminance
3 S Saturation
4 H Hue
When soft border is selected
Parameter group [1/2]
No. Parameter Adjustment
1 W Border width
2 I Border inner softness
Parameter group [2/2]
No. Parameter Adjustment
1 L Luminance
2 S Saturation
3 H Hue
Buttons for positioning the DME wipe
pattern
POS (positioner): Adjusts the position of the DME wipe
pattern.
CNTR (center): Returns the DME wipe pattern position
to the center.
When you press the [POS] button, the alphanumeric
display first shows the name of the parameter, "H" or "V,"
and then the value of the parameter.
When the [POS] button is lit green, you can adjust the
position of the pattern with the adjustment knobs.
No. Parameter Adjustment
1 H Horizontal position
2 V Vertical position
3 H (R) Relative movement in the horizontal
direction