Operation Buttons - Sony MVS-6520 User Manual

Device Control Block
The device control block is used for three-dimensional
transform operations using a DME, for wipe pattern
1 Region selection
buttons
5 MENU button

2 Operation buttons

a Region selection buttons
The operation mode allocated to the device control block
depends on the selection state of the region selection
buttons.
Region Overview of assigned operation
selection
button
• These enable the positioner (wipe pattern
M/E1, P/P
position setting) operation mode.
• You can select more than one button
simultaneously.
• These enable the three-dimensional
DME1,
DME2,
transform operation mode.
DME5 to • You can select more than one button
DME8
simultaneously.
• The [DME1] and [DME2] buttons are
enabled only when using the MKS-6570.
• The [DME5] to [DME8] buttons are
enabled only when an MVE-8000A/MVE-
9000 is used.
• This enables the VTR/disk recorder/frame
DEV
memory operation mode.
• The operation applies to the [DEV1] to
[DEV12], [FM1 CLIP], [FM2 CLIP], and
[FM LOOP] buttons.
• You can also assign the [FM3 CLIP] to
[FM8 CLIP], [RECUE], and [LOOP]
buttons in the Setup menu.
RUN CTRL This enables the keyframe operation mode.
RSZR CTRL • This enables the resizer operation mode.
• Use the [M/E1] or [P/P] button to select the
target switcher bank.
• The operation applies to the [K1RSZ] and
[K2RSZ] buttons.
38
Names and Functions of Parts of the Control Panel
position setting, and for VTR/disk recorder/frame memory
clip operation.
Region Overview of assigned operation
selection
button
• This enables the Programmable Effector
FX CTRL
software operation mode.
• The operation applies to the [FX1] to [FX4]
and [ID1] to [ID4] buttons.
For details, refer to the Help for the MPES-
FX01 Programmable Effector software.
b Operation buttons
These perform various operations. The function of each
button varies with the operation mode.
When the positioner operation mode is enabled
Name Description
a) b)
K1 to K4
These enable wipe pattern position setting
for keys 1 to 4.
a)
WIPE This enables wipe pattern position setting for
normal transitions.
POS
This enables the trackball to move the wipe
(position)
pattern in the X-axis and Y-axis directions.
X, Y These restrict which axes the trackball can
control to the X- or Y-axis.
CTR (center) This returns the pattern position to the center
of the screen.
CLR WORK Press this twice in rapid succession to reset
BUFR (clear all parameters on the target M/E or PGM/
work buffer) PST to their initial values.
a) You can configure settings in the Setup menu to allow simultaneous
selection of multiple buttons.
b) For details about operations for keys 5 to 8,
(p. 412).
3 Trackball
4 Z-ring
1 "8-Keyer Operation"