d. Push the metal bracket down until the tab
storage drive forward as shown until the tab
Figure 94. Installing the metal bracket into the plastic frame of the converter
e. Flex both sides of the plastic bracket and align pins
holes in the plastic frame of the converter.
Notes:
• Ensure that the circuit board faces downward and the connectors face toward the rear of the
bracket.
• Do not touch the circuit board on the storage drive during operation.
Figure 95. Installing the converter into the type
1
is slightly curved. Then, push the bracket with the
1
snaps into position.
1
on the plastic bracket with the corresponding
2
bracket
.
Chapter 9
Hardware removal and installation
145