Table of Contents
Advertisement
All Motorola PWBs (printed wiring boards) are manufactured by UL-recognized
manufacturers, with a flammability rating of 94V-0.
This equipment generates, uses, and can radiate electro-
!
magnetic energy. It may cause or be susceptible to electro-
magnetic interference (EMI) if not installed and used in a
WARNING
cabinet with adequate EMI protection.
If any modifications are made to product, the modifier
assumes responsibility for radio frequency interference issues.
Changes or modifications not expressly approved by
Motorola Computer Group could void the user's authority to
operate the equipment.
European Notice: Board products with the CE marking
comply with the EMC Directive (89/336/EEC). Compliance
with this directive implies conformity to the following
European Norms:
This board product was tested in a representative system to
show compliance with the above mentioned requirements. A
proper installation in a CE-marked system will maintain the
required EMC/safety performance.
For minimum RF emissions, it is essential that you implement
the following conditions:
EN55022 "Limits and Methods of Measurement of Radio
Interference Characteristics of Information Technology
Equipment". Tested to Equipment Class B.
EN50082-1:1997 "Electromagnetic Compatibility --
Generic Immunity Standard, Part 1. Residential,
Commercial and Light Industry".
- Install shielded cables on all external I/O ports
- Connect conductive chassis rails to earth ground to
provide a path for connecting shields to earth ground
- tighten all front panel screws
Advertisement
Table of Contents
