Panel-Mounting - ABB 4690 User Manual

4690 Series
Turbidity systems

3.2.3 Panel-mounting

Dimensions in mm (in.)
96 (3.78)
96
(3.78)
Fig. 3.6 Overall Dimensions
Referring to Fig. 3.5:
a
Cut a hole in the panel (see Fig. 3.6 for dimensions).
Analyzers may be close stacked to DIN 43835.
b
Loosen the retaining screw on each panel clamp.
c
Remove the panel clamp and anchors from the analyzer
case.
d
Insert the analyzer into the panel cut-out.
e
Refit the panel clamps to the case, ensuring that the panel
clamp anchors are located correctly in their slot.
f
Secure the analyzer by tightening the panel clamp
retaining screws.
Caution. The clamp must fit flat on the analyzer
casing. If the clamp is bowed, the securing screw is
overtight and sealing problems may occur.
IM/4690–EN Rev. A
12 (0.47)
191 (7.52)
2
5
Fig. 3.7 Panel-mounting
+0.8
92 (3.62
–0
Panel Cut-out
3
3
6
3 Installation
+0.03
)
–0
+0.8
92
–0
+0.03
(3.62 )
–0
1
4
7