Siemens CP 1243-7 LTE Operating Instructions Manual page 143

RoHS
The CP meets the requirements of the EC directive 2011/65/EU on the restriction of the use
of certain hazardous substances in electrical and electronic equipment.
Applied standard:
● EN 50581:2012
cULus
Underwriters Laboratories Inc. meets
● Underwriters Laboratories, Inc.: UL 61010-1 (Safety Requirements for Electrical
Equipment for Measurement, Control, and Laboratory Use - Part 1: General
Requirements)
● IEC/UL 61010-2-201 (Safety requirements for electrical equipment for measurement,
control and laboratory use. Particular requirements for control equipment)
● Canadian Standards Association: CSA C22.2 No. 61010-1-12 / CSA-IEC 61010-2-201
cULus HAZ.LOC.
Underwriters Laboratories Inc. meets
● ANSI ISA 12.12.01
Nonincendive Electrical Equipment for Use in Class I and II, Division 2 and Class III,
Divisions 1 and 2 Hazardous (Classified) Locations
● CAN CSA C22.2 No. 213-M1987, 1st Ed. (R2013)
● Non-Incendive Electrical Equipment for Use in Class I, Division 2 Hazardous Locations
APPROVED for Use in:
● Cl. 1, Div. 2, GP. A, B, C, D T4A; Ta = -20 °C...70 °C
● Cl. 1, Zone 2, GP. IIC T4; Ta = -20 °C...70 °C
FM
Factory Mutual Research (FM)
Approval Standard Class number 3600 and 3611
Approved for use in:
Class I, Division 2, Group A, B, C, D, Temperature Class T4A, Ta = 70 °C
Class I, Zone 2, Group IIC, Temperature Class T4, Ta = 70 °C
National wireless approvals
To operate the CP in certain countries approvals for wireless operation must exist, the
agreed marking must be present on the type plate and special instructions for the particular
country must be adhered to. Some of the national approvals and instructions are shown
below.
CP 1243-7 LTE
Operating Instructions, 04/2017, C79000-G8976-C381-03
Approvals
143