Husqvarna Automower 105 Operator's Manual page 15

CAUTION: The robotic lawnmower must never
run over gravel, mulch or similar material which
can damage the blades.
CAUTION: If the working area is adjacent to
water bodies, slopes, precipices or a public
road, the boundary wire must be supplemented
with an edging or the like. It must then be at
least 15 cm in height. This will prevent the
robotic lawnmower from ending up outside the
working area under any circumstance.
3.5.3 Boundaries within the working area
Use the boundary wire to isolate areas inside the
working area by creating islands around obstacles which
cannot withstand a collision, for example flowerbeds,
bushes and fountains. Lay the wire up to and around the
area to be isolated, and then return it back along the
same route. If pegs are used, the wire should be laid
under the same pegs on the return route. When the
boundary wires to and from the island are laid close
together, the robotic lawnmower can drive over the wire.
0 cm / 0"
136 - 003 -
min. 15 cm / 6"
CAUTION: The boundary wire may not be
crossed on its way to and from an island.
Obstacles that can withstand a collision, for example,
trees or bushes taller than 15 cm, do not need to be
isolated with the boundary wire. The robotic lawnmower
will turn around when it collides with this type of
obstacle.
However, to achieve careful and silent operation, it is
recommended to isolate all fixed objects in and around
the working area.
Obstacles that slope slightly, for example stones or large
trees with raised roots, must be isolated or removed.
Otherwise the robotic lawnmower can slide up onto this
kind of obstacle causing the blades to be damaged.
3.5.3.1 Secondary areas
If the working area consists of two areas which the
robotic lawnmower has difficulty travelling between, it is
recommended to set up a secondary area. Instances of
this are 25% slopes or a passage that is narrower than
60 cm. Lay the boundary wire then around the
secondary area so that it forms an island outside of the
main area. The robotic lawnmower must be moved
manually between the main and secondary area when
the lawn in the secondary area has to be cut.
Secondary
area
Main area
MAN operating mode must be used as the robotic
The
lawnmower cannot travel on its own from the secondary
area to the charging station. See
page 30 . In this mode, the robotic lawnmower will
never look for the charging station but will mow until the
battery runs out. When the battery is flat, the robotic
lawnmower will stop and the
message will appear in the display. Place the robotic
lawnmower in the charging station to charge the battery.
If the main area has to be cut straight after charging, the
Operation selection on
Needs manual charging
Installation - 15