Installation - Husqvarna Automower 105 Operator's Manual

The table below provides suggestions for different timer
settings depending on garden size. The times should be
seen as indicative. They may need to be adjusted to suit
the garden and for example grass quality and growth
during the season. Use the table as follows:
• Find a work area that closest matches the size of the
lawn.
3.13.1 Timer suggestions
Automower 105
Work area
2
100 m
2
200 m
2
300 m
2
400 m
2
500 m
2
600 m
3.13.2 To set the timer
Work hours 1: To set start and stop times for Work
•
hours 1 , enter each required time in hours and
OK to confirm the entered time.
minutes and press
Work hours 2: To set start and stop times for Work
•
hours 2 , enter each required time in hours and
OK to confirm the entered time.
minutes and press
Work days: To select the days the robotic
•
lawnmower must work, tick off the days the robotic
lawnmower will work
Reset timer: To reset values to the factory settings,
•
Reset timer and press OK .
select the
Work hours 1 or Work hours 2 , enter the
To inactivate
time 00:00 - 00:00 to reset the timer to --:-- - --:--.
A clock symbol is displayed on the start page when the
timer settings are set. The clock symbol is black when
the robotic lawnmower is not allowed to mow due to a
timer setting.

3.14 Installation

For many working areas there is no need to change the
factory settings but sometimes, depending on the lawn
complexity, the mowing result can be improved by
making manual settings.
22 - Installation
Work days per week
5
7
5
7
5
7
5
7
6
7
7
• Select an appropriate amount of work days per week
(for some work areas 7 days may be needed).
• Work hours per day shows how many hours a day
the robotic lawnmower will be allowed to work for the
selected amount of work days.
• Suggested time interval shows a time interval that
corresponds to the required work hours per day.
Work hours per day
3.5 hours
2.5 hours
7 hours
5 hours
10 hours
7 hours
13 hours
9.5 hours
13.5 hours
12 hours
14 hours
INSTALLATION
Guide width
Remote start 1
Remote start 2
Test settings
Drive past wire
The following operating settings are available via this
selection in the main menu.
Guide width: To select the distance from the guide
•
wire the mower is allowed to travel when it follows
this to and from the charging staiton.
Remote start 1: To control the robotic lawnmower so
•
that it can easier reach remote parts of the garden.
Remote start 2: To control the robotic lawnmower so
•
that it can easier reach remote parts of the garden.
• Test settings: To check the above settings.
Drive past wire: To set the distance over the
•
boundary wire that the robotic lawnmower should
travel before turning back.
For examples of installation settings, see
examples on page 27 .
3.14.1 Guide width
The guide width is a measure of how far from the guide
wire the robotic lawnmower is allowed to travel when it
Suggested time interval
07:00 - 10:30
07:00 - 09:30
07:00 - 14:00
07:00 - 12:00
07:00 - 17:00
07:00 - 14:00
07:00 - 20:00
07:00 - 16:30
07:00 - 20:30
07:00 - 19:00
07:00 - 21:00
Yard layout
136 - 003 -