Silvercrest POWER BANK Operation And Safety Notes page 16

outputs are used at the same time, the sum of
the discharging power may not exceed 3.1 A.
Use provided USB cable 7 or other
charging cable purchased from reliable
supplier. Connect USB Type A port to
USB output 1 or 3 of power bank 6 .
And then connect USB cable 7 or
other charging cable micro-USB port 9
to device to be charged. The charging
process will start automatically.
The display 4 will show the charging
status (in percentage) and the connected
output port.
In case if the charging process does not
begin immediately, press the Display /
LED button 5 lightly to begin the charg-
ing process. The current battery status of
the power bank 6 is displayed during
the charging process by the display 4 .
Note: Usage of 5 V/1A or 5 V/2A out-
put shown on display are only informa-
tion regarding to the used of USB port
and not actual measured values.
To end the charging process, separate
the USB charging cable from the mobile
device and the power bank 6 . The
charge / discharge status display 4 will
switch off after approx. 8 seconds.
16 GB