Recommended Printhead Gap Settings - Honeywell 6824 User Manual

Recommended Printhead Gap Settings

One-Part Carbonless Media
Parts Spec (g/m2)
Single 47 to 81
Two-Part Carbonless or Carbon-Backed Media
Parts Spec (g/m2)
Top 40 to 64
Bottom 40 to 81
Three-Part Carbonless or Carbon-Backed Media
Parts Spec (g/m2)
Top 40 to 64
Middle 40 to 64
Bottom 40 to 81
Four-Part Carbonless or Carbon-Backed Media
Parts Spec (g/m2)
Top 40 to 64
Middle 40 to 64
Middle 40 to 64
Bottom 40 to 81
6824 Mobile Full Page Printer User Manual
This section lists the recommended printhead gap settings for supported media
types.
Each table lists the acceptable paper thickness for each single sheet or each
sheet of multilayer paper. Total thickness must not exceed .35 mm (0.014 inch).
Note: The weight of paper may vary depending on the paper manufacturer.
Layer Thickness
(Min–Max, in mm)
.060 to .104
Layer Thickness
(Min–Max, in mm)
.051 to .082
.051 to .082
Layer Thickness
(Min–Max, in mm)
.051 to .082
.051 to .082
.051 to .104
Layer Thickness
(Min–Max, in mm)
.051 to .082
.051 to .082
.051 to .082
.051 to .104
Chapter 3 – Configure the Printer
Total Thickness
(Min–Max, in mm)
.060 to .104
Total Thickness
(Min–Max, in mm)
.103 to .186
Total Thickness
(Min–Max, in mm)
.154 to .269
Total Thickness
(Min–Max, in mm)
.206 to .351
Gap Setting
1.0
Gap Setting
1.1 or 1.2
Gap Setting
1.2 or 2.0
Gap Setting
2.2 or 3.0
41