JVC CA-NXBD3 Instruction page 12

Connecting a TV with the [HDMI]
terminal
This system can output uncompressed digital video
signals to a TV compatible with HDMI
(High-Definition Multimedia Interface).
TV
To an HDMI
terminal
HDMI cable (not supplied)
NOTE
• The HDMI video signal type can be checked in the
display window.
(Refer to "Selecting the video signal type" on this
page.)
• If the picture is distorted while an HDMI TV is
connected, turn off the main unit and turn it on
again.
• Only available for a TV compatible with HDCP
(High-Bandwidth Digital Content Protection) can be
connected to the [HDMI] terminal, so that the
uncompressed HD video signal type can be output.
• Use a High Speed HDMI Cable.
• In default settings, no HDMI audio is output from the
TV. (Refer to "HDMI AUDIO OUTPUT" on page 53)
CAUTION
• Connect the main unit directly to a TV (or a monitor)
without routing through a video cassette recorder
(VCR). Otherwise picture distortion may occur
during playback. (Routing the connection through a
VCR, however, does not affect the audio quality.)
Main unit
Direct connection
• Connecting the main unit to a VCR-built-in-TV may
also cause picture distortion during playback.
7
Main unit
(rear view)
MONITOR OUT
HDMI
TV
(or monitor)
VCR
SCAN MODE
Selecting the video signal type
To view an image on the TV screen, select the video
signal type correctly according to the TV after
connecting the main unit to the TV.
1
Change to the most appropriate
settings on your TV in advance.
2
Turn on the main unit. (Refer to
"Connecting the power cable" on
page 10 and "Turning on the main
unit" on page 12.)
3
Press [SCAN MODE].