Siemens SINUMERIK 840D sl Operating Manual page 543

Loading empty magazine location directly with tool
Several magazines
If you have configured several magazines, the "Load to ..." window appears after pressing
the "Load" softkey.
If you do not want to use the suggested empty location, then enter your desired magazine
and magazine location. Confirm your selection with "OK".
Multiple load points
If you have configured several loading points for a magazine, then the "Loading Point
Selection" window appears after pressing the "Load" softkey.
Select the required loading point and confirm with "OK".
Unloading tools
Milling
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
1. Position the cursor at an empty magazine location where you want to
load a tool and press the "Load" softkey.
The "Load with ..." window opens.
Select the desired tool in the " ... Tool" field and press the "OK" softkey.
1. Place the cursor on the tool that you would like to unload from the
magazine and press the "Unload" softkey.
2. Select the required load point in the "Loading Point Selection" window.
3. Confirm your selection with "OK".
- OR -
Undo your selection with "Cancel".
Tool management
11.5 Tool list
543