Heating-Up After A Long Standing Time / On The Fi Rst Use - Silvercrest SEM 1100 A2 Operating Instructions Manual

Heating-up after a long standing time / on the fi rst use
If you have not used it for some time, preheat the appliance as follows:
1) Fill the water tank 1 with water.
2) Place either the large q or the small espresso sieve 0 in the sieve carrier w.
3) Insert the sieve carrier w into the appliance by placing it at the marking
"INSERT" and then turning it anticlockwise to the marking "LOCK".
4) Place a cup under the sieve carrier w.
5) Close the steam regulation knob 2 (turn it as far as it will go in the direction " - ").
6) Switch the appliance on with the on/off switch 3.
7) The red heating-up control lamp i glows.
8) Turn the rotary switch 5 to the position "
into the appliance. As soon as water fl ows from the sieve carrier opening, turn
the rotary switch 5 back to the position "
9) As soon as the green heating-up control lamp 4 glows, turn the rotary switch 5
to the position "
you need to empty the cup in between. To do this, stop the process for a moment
by turning the rotary switch 5 back to the position „
10) After approx. 1 minute turn the rotary switch 5 back to the position "
11) Wait until the green heating-up control lamp 4 glows again. The warming-up
is concluded. You can now prepare espresso.
SEM 1100 A2
". Allow the water to fl ow for about 1 minute. It may be that
". The pump begins to pump water
".
".
GB
CY
".
9