Canon imagePRESS A3200 Installation And Service Manual page 115

Cable connector
4-pin connector (not used)
SATA (5-pin) connector
to each HDD
4-pin connector to DVD drive
data/power cable
SATA (5-pin) connector
(not used)
T
O REMOVE THE POWER SUPPLY
S P
ERVICE ROCEDURES
Pin(s)
1
2
3
4
1
2
3
4
5
1
2
3
4
1
2
3
4
5
1. Shut down the imagePRESS Server, remove all cables from the back, and then open the
system (see page 59).
In order to remove the power supply, you must remove the left and right panels.
2. Remove the 24-pin power cable from connector PW2 on the motherboard.
3. Remove the 8-pin power cables from connectors PW1 and PW3 on the motherboard.
4. Remove the SATA power cables from the HDDs.
5. Remove the ferrite that is installed around the HDD power cables.
Carefully pry open the latch on the side of the ferrite, and remove the ferrite from the cables.
Set aside the ferrite so that you can replace it later.
6. Detach the SATA power cable from the power connector of the dual cable for the DVD drive.
7. Remove any tie wraps securing the power cables to the chassis.
8. Place the imagePRESS Server in the upright position.
Wire color Voltage
Yellow&White +12V
Black COM
Black COM
Red +5V
— not connected
Black COM
Red +5V
Black COM
Yellow&White +12V
Yellow&White +12V
Black COM
Black COM
Red +5V
— not connected
Black COM
Red +5V
Black COM
Yellow&White +12V
Connection
HDD
DVD drive data/power cable
DVD drive
115