Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
2. Replace the copier interface board to connector PCI-E1 x8 on the motherboard (see
When installing the board, verify the following:
• The board is installed in connector PCI-E1 x8 on the motherboard, and the board
connector is properly aligned with the PCI connector. For the correct connector and slot
assignments, refer to
• The bracket screw is installed on the back panel slot.
• Unused slots have slot covers installed on the back panel. Uncovered slots reduce the air
flow and could cause the imagePRESS Server to overheat.
3. Replace the bracket cover plate to the back panel (see
4. Reassemble the imagePRESS Server but do not power on the system.
Verifying the functionality of a new motherboard installation
After you install a new motherboard and reassemble the system, you first need to verify all
functionality by using the single-use dongle to enter Service Mode. Be sure to verify the
motherboard functionality before transferring options to the new motherboard (described on
page
90); do not transfer options prematurely.
Entering Service Mode allows you to make sure that the new motherboard solves the problem
that you are troubleshooting. Service Mode is a temporary state that allows you to test the
motherboard. Service Mode is exited automatically when you expend the single-use dongle to
transfer options (see
page
Service Mode is not indicated on the monitor or the imagePRESS Server Control Panel but
is entered once you power up with a new motherboard installed and the single-use dongle
installed on the USB port.
Figure 14 on page
55.
90).
Figure 13 on page
54).
87
page
67).
Advertisement
Table of Contents
