Table of Contents
Advertisement
S
ERVICE
3. Detach the UIB cable from its connector on the motherboard.
For the connector location, see
4. Remove the panel from the chassis.
Carefully guide the UIB cable out of the chassis as you remove the panel.
5. To replace the top panel, first route the UIB cable through the chassis and connect it to the
motherboard.
For the connector location on the motherboard, see
page
76.
6. Position the top panel on top of the chassis (see
Place the six hooks on the underside of the panel into the slots in the top of the chassis, and
then slide the top panel toward the back of the chassis to engage the hooks.
You may need to tap the front edge of the panel toward the back of the chassis to
N
:
OTE
engage the panel completely.
Removing and replacing boards
This section includes procedures for removing and replacing the following boards:
• Copier interface board
• Graphics board
• User interface board
• Motherboard
The imagePRESS Server is shipped from the factory with a standard board configuration, as
shown in
that accompanies the option kit.
P
ROCEDURES
Figure 16 on page
Figure 14 on page
55. If an optional component is installed, see the documentation
57.
Figure 16 on page 57
and
Figure 21 on page
65).
66
Figure 26 on
Advertisement
Table of Contents
