Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
T
O REMOVE MOTHERBOARD COMPONENTS FROM THE MOTHERBOARD
1. Shut down the imagePRESS Server, remove all cables from the back, and then open the
system (see
page
In order to access the motherboard, you must remove the left panel.
2. Remove the copier interface board from the motherboard (see
In order to access the mounting screw for the board bracket, you must first remove the
bracket cover plate from the back panel.
Remove the mounting screw that secures the board bracket to the back panel. Grasp the
board at the front and back edge and gently pull it straight out of its connector on the
motherboard. Place the board on an antistatic surface.
3. Remove the following cables attached to the motherboard (for the location of each connector
on the motherboard, see
• Front fan cable
• Back fan cable
• HDD data cables
• DVD drive data/power cable
• UIB cable
• Front USB cables
To remove the motherboard tray, you may first need to cut the tie wrap that secures the
front USB cables to the chassis.
• 8-pin motherboard power cable (PW1)
• 8-pin motherboard power cable (PW3)
• 24-pin motherboard power cable (PW2)
• Power button cable
• Reset button cable
• Speaker cable
T
O REMOVE THE MOTHERBOARD TRAY
N
:
This procedure assumes that you have removed the copier interface board and cables
OTE
from the motherboard, as described in
motherboard" on page
1. Remove the front fan (see
2. Remove the back fan (see
N
:
If you do not remove the back fan, you may damage the back fan cable when removing
OTE
the motherboard.
59).
Figure 16 on page 57
"To remove motherboard components from the
79.
page
108).
page
111).
page
67).
and
Figure 17 on page
58):
79
Advertisement
Table of Contents
