Program Preset Transition - Panasonic AG-HMX100P Operating Instructions Manual

To select a pattern
The currently selected pattern number is shown in the
event number, transition, pattern number, and internal video
display area of the setting screen (
PATTERN
0001
1
Press the PATTERN button to turn on.
2
Set the pattern number by entering a numeric
value with the numeric keys or using the + and
− keys.
3
Press the key.
 NOTE
If the number with no corresponding pattern (invalid
number) is specified, the nearest valid pattern number
appears.
To set the transition time
the area where the event number, transition time, pattern
number, and internal video are displayed on the setting
screen (
The factory default setting is [02:00
ME TIME
02:00
F
The maximum value that can be set is [33:09
F
 NOTE
Even if a value exceeding the maximum value is selected, the
maximum value is automatically set.
1
Press the ME setting button to turn on.
2
Set the transition time by entering a numeric
value with the numeric keys or using the TIME
rotary control.
Example: To set "2:05" (2 seconds 5 frames),
enter "2.5."
be used to select the transition time display form
3
Press the key.
] [2 seconds].
F
F
]
F


Program Preset Transition

Program preset transition is an effect of switching from
switching direction only from preset video to program video
 NOTE
During program preset transition, the buses are switched to
each other every time transition is carried out.
This state of bus switching can be checked with lighting and
flashing of the ME PVW button.
When the buses are in the same state as the initialization,
the ME PVW button is lighted. When transition is carried out
once and the bus source is switched to the other, the ME PVW
button flashes.
Keying
(

The following diagram shows an example of the basic
button.
1
Select source video A and source video B
( page 33).
2
Slide the transition lever to the A side (or B side).
3
Select the key pattern to use (
pattern" on this page).
Patterns registered as direct patterns (
can be used.
4
Process the selected pattern by applying
effects including border, shadow, and trail
( page Vol.2-3).


"To select a

35