Siemens sitrans LR 400 Instruction Manual And Users Manual page 59

4.4 Digital Output
4.4.1: Function DO (F = Alarm)
Assignment of the digital output
Value
Here you can select whether the digital output supplies the upper or lower limit value of
level or volume or an alarm (device error, measurement error; see Parameter 3. 1 ) to the
control system. If you select the
Selection of a limit value enables Parameter 4.4.4. If you select Alarm or No function in
this parameter, Parameter 4.4.4 will not be visible.
Note:
The value of Parameter 4.4.4 is determined by the MaxLim or MinLim selection
chosen in 4.4.1 (Function DO).
4.4.2: Error Level (F = D: Error Signal)
Level for the error signal to alarm in Analog or Digital output
Value
When D is selected, all errors are displayed. When D+F is selected, there is special
handling for failsafe. When D+F+W is selected, there is special handling for warnings.
4.4.3: Signal Type DO (F = Relay closes)
Value
7ML19985FH04
MaxLim level
MinLim level
MaxLim volume
MinLim volume
MaxLim mass
MinLim mass
Alarm
No function
No function
D: Error signal
D+F: Error signal
D+F+W: Error signal
Relay closes
Relay opens
SITRANS LR 400 – INSTRUCTION MANUAL
option, the digital output is switched off.
Page 56