Sharp SB-29S Service Manual page 11

1. Remove the panel B-A and faucet ass'y in accordance with "REMOVE OF PANEL B-A".
2. Put the jig into rear of the unit.
3. Remove 2 screws holding the switch ON/OFF ass'y.
4. Remove 4 screws holding the condenser ass'y and remove 6 screws from the side plate L-R to the tank
support.
5. Remove 4 screws holding the back plate and remove lead wire earth from side plate-L.
6. Turn front unit and remove 4 screws holding the side plate reinforce to the stand.
7. Now the side plate L-R are free.
Side plate-R
Screw
Side plate reinforce
Stand
1. Remove 2 screws holding the top plate and detach out the top plate from the unit.
2. Remove 4 screws holding the space tank.
3. Remove 2 clamp for silicone tube from space tank.
4. Now the space tank is free.
REMOVE OF SIDE PLATE L-R
Tank support
Screw
REMOVE OF SPACE TANK
Space tank
Screw
SW. fixing plate
Switch ON/OFF
Screw
Lead wire earth
Fig. 11
Clamp for silicone tube
Silicone tube
Fig. 12
11
Screw
Jig
Screw
Condenser ass'y
Back plate
Screw
Side plate-L
Top plate
Tank cooler ass'y