Component Replacement Procedure - Sharp SB-29S Service Manual

Before beginning the service inspection and/or repair you will need to disconnect the power cord
from the Hot & Cold water dispenser and remove the bottle from the reservoir.
1. Remove the insulating seal cork tape from terminal cover.
2. Remove the cover strap fixing the terminal cover.
3. Disconnect the lead wire blue and remove the PTC relay from compressor.
4. Now the PTC relay is free.
Compressor
1. Remove the PTC relay in accordance with "REMOVE OF PTC RELAY".
2. Disconnect the lead wire yellow and remove the thermo motor from compressor.
3. Now the thermo motor is free.
Compressor
Thermo motor

COMPONENT REPLACEMENT PROCEDURE

REMOVE OF PTC RELAY
PTC relay
Fig. 1
REMOVE OF THERMO MOTOR
Fig. 2
Terminal cover
PTC relay
6
Terminal cover
Cover strap
Lead wire blue
Cover strap
Lead wire yellow