Table of Contents
Advertisement
6 PROGRAMMING
The general programming procedure is as detailed in the relevant Instruction Manual, but with an additional
frame in the
Set Up Instrument
xxxxxxxxxxx
DIAGNOSTIC INFORMATION
Next 5 weekly service =
Next yearly service
Monitor in service
6.1 Serial Interface Page
Refer to Section 6.3 (Set Up Instrument) in the relevant Instruction Manual.
SET UP SERIAL INTERFACE
Baud Rate = xxxx
6
page.
Page 0
xx/x
PAGE 1.0
DD/MM
=
DD/MM/YY
MAINTENANCE AND CALIBRATION.
Enter security code
SET UP INSTRUMENT
Enter security code
SET UP INSTRUMENT
Control temperature =
Display units as =
Alter setup security code =
CLOCK SETUP.
Date (DD/MM/YY) = xx/xx/xx
Time (HH:MM)
SET UP SERIAL INTERFACE
Fig. 6.1 Location of Serial Data Interface Page
PAGE 3.3
Parity = xxxx
ID = xx
PAGE 2.0
xxxx
PAGE 3.0
xxxx
PAGE 3.1
Software issue =
x
xx.x'C
Display units =
<units>
xxx
xxxx
PAGE 3.2
= xx:xx
PAGE 3.3
Baud Rate = xxxx
Parity = xxxx
ID = xx
SET UP CURRENT OUTPUTS
Output range 1 = 0 to
Calibration hold = NO
Output range 2 = 0 to
Calibration hold = NO
Output type = xx to xx mA
Test output = NO
Baud Rate
Select the transmission rate required (1200 slowest, 9600
fastest).
Parity
Select the appropriate parity (None, Odd or Even) to match the
computer terminal or host computer.
Transmitter Identification
Assign the transmitter an identification number (1 to 99) – see
Section 4.1. The identification number allows more than one
transmitter to be accessed via the communication channel.
Set Up Serial Interface
PAGE 4.0
xxx <units>
xxx <units>
Advertisement
Table of Contents
