Table of Contents
Advertisement
Configuring IPMI Over LAN Using iDRAC Settings Utility
To configure IPMI over LAN:
1.
In the iDRAC Settings Utility, go to Network.
The iDRAC Settings Network page is displayed.
2.
For IPMI Settings, specify the values.
For information about the options, see the
3.
Click Back, click Finish, and then click Yes.
The IPMI over LAN settings are configured.
Configuring IPMI Over LAN Using RACADM
To configure IPMI over LAN using set or config command:
1.
Enable IPMI over LAN:
–
Using config command: racadm config -g cfgIpmiLan -o cfgIpmiLanEnable 1
–
Using set command: racadm set iDRAC.IPMILan.Enable 1
NOTE: This setting determines the IPMI commands that are executed using IPMI over LAN interface. For more
information, see the IPMI 2.0 specifications at intel.com.
2.
Update the IPMI channel privileges:
–
Using config command: racadm config -g cfgIpmiLan -o cfgIpmiLanPrivilegeLimit
<level>
–
Using set command: racadm set iDRAC.IPMILan.PrivLimit <level>
where <level> is one of the following: 2 (User), 3 (Operator) or 4 (Administrator)
3.
Set the IPMI LAN channel encryption key (if required):
–
Using config command: racadm config -g cfgIpmiLan -o cfgIpmiEncryptionKey <key>
–
Using set command: racadm set iDRAC.IPMILan.EncryptionKey <key>
where <key> is a 20-character encryption key in a valid hexadecimal format.
NOTE: The iDRAC7 IPMI supports the RMCP+ protocol. For more information, see the IPMI 2.0 specifications
at intel.com.
Enabling or Disabling Remote RACADM
You can enable or disable remote RACADM using the iDRAC7 Web interface or RACADM. You can run up to five remote
RACADM sessions in parallel.
Enabling or Disabling Remote RACADM Using Web Interface
To enable or disable remote RACADM:
1.
In iDRAC7 Web interface, go to Overview → iDRAC Settings → Network → Services.
The Services page is displayed.
2.
Under Remote RACADM, select Enabled. Else, select Disabled.
114
iDRAC Settings Utility Online Help .
Advertisement
Table of Contents
Troubleshooting
