Setting Alert Recurrence Event; Setting Alert Recurrence Events Using Idrac7 Web Interface; Setting Alert Recurrence Events Using Racadm; Setting Event Actions - Dell iDRAC7 User Manual

Setting Alert Recurrence Event

You can configure iDRAC to generate additional events at specific intervals if the system continues to operate at a
temperature which is greater than the inlet temperature threshold limit. The default interval is 30 days. The valid range is
0 to 365 days. A value of '0' indicates that the event recurrence is disabled.
NOTE: You must have Configure iDRAC privilege to set the alert recurrence value.

Setting Alert Recurrence Events Using iDRAC7 Web Interface

To set the alert recurrence value:
1. In the iDRAC7 Web interface, go to Overview → Server → Alerts → Alert Recurrence.
The Alert Recurrence page is displayed.
2. In the Recurrence column, enter the alert frequency value for the required category, alert, and severity type(s).
For more information, see the
3. Click Apply.
The alert recurrence settings are saved.

Setting Alert Recurrence Events Using RACADM

To set the alert recurrence event using RACADM, use the eventfilters subcommand. For more information, see the
RACADM Command Line Reference Guide for iDRAC7 and CMC .

Setting Event Actions

You can set event actions such as perform a reboot, power cycle, power off, or perform no action on the system.
Related Links
Filtering Alerts
Enabling or Disabling Alerts

Setting Event Actions Using Web Interface

To set an event action:
1. In iDRAC7 Web interface, go to Overview → Server → Alerts . The Alerts page is displayed.
2. Under Alerts Results, from the Actions drop-down menu, for each event select an action:
– Reboot
– Power Cycle
– Power Off
– No Action
3. Click Apply.
The setting is saved.

Setting Event Actions Using RACADM

To configure an event action, use one of the following:
154
iDRAC7 Online help .