Setting The Nominal Temperature; Programming The Switch Off Time; Programming The Switch On Time - Silvercrest SWW 1500 A1 Operating Instructions Manual

Setting the nominal temperature

GB
IE
Programming the switch off time

Programming the switch on time

12
♦ Press the button POWER/MODE
play , the nominal temperature and the indicator LOW blinks for 5 seconds.
♦ Whilst the nominal temperature is blinking in the display
the buttons +/- 4 and/or
15°C to 27°C. Each press of the button +/-
reduces the nominal temperature by 1°C. Wait approx. 5 seconds until the
nominal temperature is continuously shown in the display
now saved and the heating element
♦ Press the button POWER/MODE
high heat output (HIGH). In the display
as the indicator HIGH blink for 5 seconds.
NOTICE
► As soon as the temperature at the temperature sensor integrated into the
device has reached the set nominal temperature the heating element
switches off and in the display
► As soon as the temperature falls below the nominal temperature the
heating element
9
HIGH and/or LOW lights up continuously.
♦ Beforehand, select the desired heating mode (HIGH or LOW) and, if desired,
the nominal temperature (see Chapter "Heating operation" and "Setting the
nominal temperature").
♦ Press the button AUTO OFF
indicator for automatic switch off AUTO OFF
for 5 seconds.
♦ Whilst the preset time is blinking in the display
+/- and/or to set the desired switch off time between 1 hour and
4 13
24 hours. As soon as the set heating mode (HIGH or LOW) or the set target
temperature is again indicated in the display
and the appliance switches itself off with the lapse of the time period.
♦ Press the button AUTO OFF
the switch off time. In the display
♦ Activate the main switch POWER
standby operation.
♦ Press the button AUTO ON
indicator for automatic switch on AUTO ON
for 5 seconds.
Handling and operation
3 and/or
to set the desired nominal temperature from
13
9 switches on.
3 and/or
the indicator HIGH and/or LOW blinks.
switches on again and in the display
5 and/or . In the display
14
5 and/or
14
the indicator AUTO OFF
to switch the device on and to shift into
6
and/or . In the display
2 11
repeatedly until, in the dis-
12
press one of
4 and/or 13 increases or
. The setting is
again if you want to set the
12
the nominal temperature as well
the indicator
appears the
and the preset time blinks
press one of the buttons
, the setting has been accepted
again if you want to deactivate
goes out.
appears the
and the preset time blinks
SWW 1500 A1
9