Silvercrest SWW 1500 A1 Operating Instructions Manual

Silvercrest SWW 1500 A1 Operating Instructions Manual

Wave heater
Hide thumbs Also See for SWW 1500 A1:

Advertisement

Wave Heater SWW 1500 A1
6
Wave Heater
Operating instructions
KOMPERNASS GMBH
BURGSTRASSE 21 · D-44867 BOCHUM
www.kompernass.com
ID-Nr.: SWW 1500 A1-05/11-V3
IAN: 66900

Advertisement

Table of Contents
loading

Summary of Contents for Silvercrest SWW 1500 A1

  • Page 1 Wave Heater SWW 1500 A1 Wave Heater Operating instructions KOMPERNASS GMBH BURGSTRASSE 21 · D-44867 BOCHUM www.kompernass.com ID-Nr.: SWW 1500 A1-05/11-V3 IAN: 66900...
  • Page 2 SWW 1500 A1...
  • Page 3: Table Of Contents

    Importer ............. . . 17 SWW 1500 A1...
  • Page 4: Introduction

    Information regarding these operating instructions These operating instructions are a component of the Thermal wave heater SWW 1500 A1 (subsequently refered to as the device) and provide you with important information for proper use, safety, connections as well as operation of the device.
  • Page 5: Warnings

    If the situation is not avoided it could lead to property damage. ► Observe the instructions in this warning to avoid property damage. NOTICE ► A notice signifi es additional information that assists in the handling of the device. SWW 1500 A1...
  • Page 6: Intended Use

    Before putting the device back into service have a new mains power cord installed by an authorised specialist. ► Under no circumstances should you open the device housing. There is a danger of electric shock if voltage carrying connections are touched or the electrical and/or mechanical construction is changed. SWW 1500 A1...
  • Page 7: Basic Safety Instructions

    ■ Do not subject the device to spray and/or dripping water and do not place any objects fi lled with liquid, such as vases or open drink containers, on or near the device. SWW 1500 A1...
  • Page 8: Initial Use

    NOTICE ► If possible preserve the device's original packaging during the warranty period so that in the case of a warranty claim you can package the device properly for return. SWW 1500 A1...
  • Page 9: Requirements For The Set-Up Location

    Before initial use ■ Remove all packaging materials and all transport securing devices from the device. NOTICE ► With initial use, for a brief period, a light odour accumulation can occur. This is normal and completely harmless. SWW 1500 A1...
  • Page 10: Electrical Connection

    Device Display AUTO ON button POWER/MODE button +/- buttons AUTO OFF button POWER main switch Mains power cord Pedestals Heating element Carrying handle Remote control AUTO ON button POWER/MODE button +/- buttons AUTO OFF button Battery compartment SWW 1500 A1...
  • Page 11: Assembly

    If in doubt, call a professional. NOTICE ► When selecting the mounting location make sure that a suitable mains wall socket is located within the plug-in radius of the mains power cord. SWW 1500 A1...
  • Page 12 Insert the rawlplugs into the holes and screw in the M4 x 42 screws. Allow the screw heads to stick out slightly. ♦ Now hang the device on the screws and mark the drill hole for the angle bracket SWW 1500 A1...
  • Page 13: Handling And Operation

    Press the button POWER/MODE and/or . The device switches on with the low heat output (LOW). In the display appears ♦ Press the button POWER/MODE and/or again to set the high heat output (HIGH). In the display appears . SWW 1500 A1...
  • Page 14: Setting The Nominal Temperature

    ♦ Press the button AUTO ON and/or . In the display appears the indicator for automatic switch on AUTO ON and the preset time blinks for 5 seconds. SWW 1500 A1...
  • Page 15: Overheating Protection

    The device now switches on if the room temperature drops below 7°C. Topple over protection The device is equipped with topple over protection which automatically switches the heating element off if the device topples over. In addition a warning tone sounds for 1 minute. SWW 1500 A1...
  • Page 16: Cleaning

    This obligation is intended to ensure that batteries are disposed of in an environmentally safe fashion. Batteries should only be returned in a fully discharged condition. SWW 1500 A1...
  • Page 17: Troubleshooting

    Malfunction of the integrated If the indicator continues to appear the indicator temperature sensor get in touch with the customer service department. NOTICE ► If you cannot solve the problem with the aforementioned methods please contact customer service. SWW 1500 A1...
  • Page 18: Appendix

    This device conforms with regard to compliance with the basic requirements and other relevant provisions of the low voltage directive 2006/95/EC and the electromagnetic compatibility directive 2004/108/EC. The complete original declaration of conformity can be obtained from the importer. SWW 1500 A1...
  • Page 19: Warranty

    Service Great Britain Tel.: 0871 5000 720 (£ 0.10/Min.) E-Mail: kompernass@lidl.co.uk IAN 66900 Service Ireland Tel.: 1890 930 034 (0,08 EUR/Min., (peak)) (0,06 EUR/Min., (off peak)) E-Mail: kompernass@lidl.ie IAN 66900 Importer KOMPERNASS GMBH BURGSTRASSE 21 44867 BOCHUM, GERMANY www.kompernass.com SWW 1500 A1...

This manual is also suitable for:

66900

Table of Contents