ABB ACS800 Application Manual page 35

Index Parameter name /
value
PAR 22.08&09
22.08 ACC PTR
-255.255.31 ...
+255.255.31 / C.-32768
... C.32767
22.09 DEC PTR
-255.255.31 ...
+255.255.31 / C.-32768
... C.32767
26 MOTOR CONTROL
26.06 FLUX REF PTR
-255.255.31 ...
+255.255.31 / C.-32768
... C.32767
40 PID CONTROL
40.07 ACTUAL1 INPUT SEL
PARAM 40.25
40.25 ACTUAL1 PTR
-255.255.31 ...
+255.255.31 / C.-32768
... C.32767
83 ADAPT PROG CTRL
83.01 ADAPT PROG CMD
STOP
START
EDIT
83.02 EDIT COMMAND
NO
PUSH
DELETE
Description
Acceleration and deceleration times given by parameters 22.08 and 22.09
Selects the source for 22.01
Parameter pointer or constant value. See Parameter
Selects the source for 22.01
Parameter pointer or constant value. See Parameter
Parameters through which the Adaptive Program can control the flux of the
drive.
Selects the source for the flux reference.
Parameter pointer or constant value. See Parameter
Parameters through which the Adaptive Program can affect on the process
PID control.
Source selected by parameter 40.25.
Selects the source for 40.07
Parameter pointer or constant value. See Parameter
Execution control of the Adaptive Program.
Selects the operation mode for the Adaptive Program.
Stop. The program cannot be edited.
Run. The program cannot be edited.
Stop to edit mode. The program can be edited.
Selects the command for the block placed in the location defined by
parameter 83.03. The program must be in edit mode. (See parameter 83.01.)
Home value. The value automatically restores to NO after an editing
command has been executed.
Shifts the block in the location defined by parameter
subsequent blocks one location up. A new block can be placed in the emptied
location by programming the Block Parameter Set as usual.
Example: A new block needs to be placed in between the current block
number four (parameters 84.20...84.25) and five (parameters 84.25...84.29).
In order to do this:
- Shift the program to the edit mode by parameter 83.01.
- Select location number five as the desired location for the new block by
parameter 83.03.
- Shift the block in location number 5 and all subsequent blocks one location
forward by parameter 83.02
- Program the emptied location number 5 by parameters 84.25 to 84.29 as
usual.
Deletes the block in the location defined by parameter
subsequent blocks one step down.
Actual signals and parameters in ACS800 Standard Application Program
10.04.
10.04.
10.04.
10.04.
83.03
(selection PUSH).
FbEq
15
100 = 1 s
100 = 1 s
6
100 = 1%
and the
83.03 and shifts the
35