Motor Stator Assembly Removal - NEC D2246 Maintenance Manual

4.5 MOTOR STATOR ASSEMBLY REMOVAL
Follow these steps to remove the motor stator assembly.
1. Turn off the D2246.
2. Disconnect the dc power supply.
3. Remove the G9QST PCB (see Section 4.1).
4. Remove the earth pad assembly (see Section 4.3).
5. Remove the G9QSQ PCB (see Section 4.4).
6. Loosen the four screws that secure the fan (see Figure 4-6) and remove the fan by
lifting it straight up.
7. Remove the rotor using the special rotor handling tool (see Figure 4-7).
8. Loosen the three screws that secure the claw stopper (see Figure 4-7) and remove
the claw stopper.
9. Loosen the three screws that secure the motor shield and remove it.
10. Slide the motor stator assembly carefully along the spindle to remove it.
Figure 4-7 D2246 Stator Assembly
4-6