Connecting The Server Enclosure To The Mains - Fujitsu PRIMERGY CX400 M4 Operating Manual

Hardware installation
5.3 Connecting the server enclosure to the
mains
The system has two bays for hot-plug PSUs. Each hot-plug PSU can be
replaced during operation (see the "FUJITSU Server PRIMERGY CX400 M4
Server Enclosure Upgrade and Maintenance Manual").
V
CAUTION!
The server enclosure is automatically set to a mains voltage in the range
100 - 240 V. You may only operate the server enclosure if its rated
voltage range corresponds to the local mains voltage.
Ê Connect the power cord to the server enclosure PSU.
Ê Connect the mains connector to an outlet on the rack's socket strip (see also
Technical Manual for the rack).
I
A phase redundancy in the power supply of the server enclosure can be
set up if two hot-plug PSUs are installed.
In this case, each of the PSUs is either connected to two different phases
or to two separate circuits of the internal power supply network.
50 Operating Manual
CX400 M4