Installing Front Weights - Toro Sand Pro 3040 Operator's Manual

WARNING
Incorrect battery cable routing could damage
the machine and cables and cause sparks.
Sparks can cause the battery gasses to
explode, resulting in personal injury.
• Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always connect the positive (red) battery
cable before connecting the negative
(black) cable.
WARNING
Battery terminals or metal tools could short
against metal machine components causing
sparks. Sparks can cause the battery gasses to
explode, resulting in personal injury.
• When removing or installing the battery,
do not allow the battery terminals to touch
any metal parts of the machine.
• Do not allow metal tools to short between
the battery terminals and metal parts of
the machine.
2. Secure the positive cable (red) to the positive (+)
terminal with a bolt (1/4 x 5/8 inch) and a locknut
(Figure 5).
5

Installing Front Weights

Parts needed for this procedure:
–
Front weight kit(s) as needed
Procedure
This machine has been designed in accordance with ANSI B71.4-2012. However, when attachments are installed on the
machine additional weight is required to comply to the standards.
Use the chart below to determine the combinations of additional weight required. Order parts from your local Authorized Toro
Distributor.
Attachment
Spiker kit (08755)
Rahn Groomer
QAS Utility Box
Note: Additional weight is not required if the machine is equipped with the Front Hydraulic Lift Kit, Model 08712.
Additional Front Weight
Required
23 kg (50 lb)
23 kg (50 lb)
23 kg (50 lb)
12
1. Small black cable
2. Positive (+) battery cable
3. Secure the small black wire and the negative cable
(black) to the negative (-) terminal of the battery with a
bolt (1/4 x 5/8 inch) and locknut (1/4 inch)
4. Coat the terminals and mounting fasteners with
petroleum jelly to prevent corrosion.
5. Slide the rubber boot over the positive (+) terminal to
prevent a possible short from occurring.
6. Install the top battery hold-down to the side battery
hold-downs and secure it with the washers and wing
nuts.
Weight Kit Part Number
100-6442
100-6442
100-6442
Figure 5
3. Negative (-) battery cable
(Figure
Weight Description
8 x 6.5 lb plate weight
8 x 6.5 lb plate weight
8 x 6.5 lb plate weight
5).
Qty.
1
1
1