Towing The Machine; Breaking In The Machine; Becoming Familiar With The Machine - Toro Sand Pro 3040 Operator's Manual

Towing the Machine

In case of emergency, you can tow the machine for a short
distance. However, we do not recommend this as a standard
procedure.
Important: Do not tow the machine faster than 1.6
km/h (1 mph), because the drive system may be
damaged. If the machine must be moved more than 50
meters (55 yards), transport it on a truck or a trailer.
The tires may lock up if you tow the machine too fast.
If this occurs, stop towing the machine and wait for the
traction circuit pressure to stabilize before resuming
towing at a slower speed.

Breaking in the Machine

New engines take time to develop full power. Drive systems
have more friction when they are new, placing additional load
on the engine.
Allow the first 8 hours of operating time for the break-in
period.
Since the first hours of operation are critical to future
dependability of the machine, monitor the functions and
performance closely so that you can notice and correct minor
difficulties, which could lead to major problems. Inspect the
machine frequently during the break-in period, for signs of oil
leakage, loose fasteners, or any other malfunction.
Becoming Familiar with the
Machine
Refer to the attachment Operator's Manual for specific
operating instructions for the attachment.
Practice driving the machine, because its operating
characteristics are different than some utility vehicles. 2 points
to consider when operating the vehicle are transmission speed
and engine speed.
To maintain somewhat constant engine speed, press the
traction pedal slowly. This allows the engine to keep up with
the ground speed of the vehicle. By contrast, pushing down
quickly on the traction pedal reduces the engine speed; as a
result, there will not be enough torque-power to move the
vehicle. Therefore, to transfer maximum power to the wheels,
move the throttle to F
AST
By comparison, maximum ground speed with no load results
when the throttle is in the F
is slowly but fully pressed. Always keep the engine speed high
enough to deliver maximum torque-power to the wheels.
and slightly press the traction pedal.
position and the traction pedal
AST
CAUTION
Operating the machine demands attention to
prevent tipping or loss of control.
• Use care when entering and leaving sand traps.
• Use extreme caution around ditches, creeks, or
other hazards.
• Use caution when operating the machine on a
steep slope.
• Reduce your speed when making sharp turns or
when turning on hillsides.
• Avoid sudden stops and starts.
• Do not go from reverse to full forward without
first coming to a complete stop.
Note: If the attachment adapter becomes stuck to the
traction unit adapter, insert a pry bar or a screwdriver into the
pry slot to disengage the parts
1. Pry slot
21
(Figure 19).
1
G003783
Figure 19