Before Using The Water Dispenser; Filling The Water Tank - Kenwood K4D496X18 Installation Instructions Manual

before using the water dispenser

Before using the water dispenser, clean the water tank and water valve
component first.
1. Take out the water tank by gripping it tightly on both sides, then with some
force keep pulling it upward and toward your direction until removed.
2. Unlock and take off the water tank cover and sealing ring, and wash the
water tank, its cover and sealing ring under water. After washing, drain the
water from inside the tank and replace the cover and sealing ring. Make
sure to lock the cover to the water tank on both sides. Make sure the
sealing ring is replaced properly.
3. Take out the water valve component by using a thin flat-headed tool to
insert into the head of the water valve to pry it open, then pull out the water
valve component and wash it under water.
4. After washing, re-assemble it back. Align the bottom of the water valve component with the slot
on the unit, then press down the water valve component until a click is heard. Check and ensure
the water valve component sits and locks properly and securely on the unit.
5. Insert the water tank into the water valve. Align the sealing ring with the water valve, then press
down the water tank into the water valve until it sits properly and securely.
• If the water in the water tank is not used for a long period, it is recommended that the
water be replaced.
• If the water tank is used for the first time, or if it has been kept unused for a long period, it
needs to be cleaned before use.

filling the water tank

Pour drinking water into the water tank through the small lid. Close the lid after filling.
• Do not fill above the level, otherwise, it may overflow.
• Before filling with water, ensure that the water tank is steady and in a correct position.
• Apart from drinking water, other beverages (such as milk, juice, carbonated beverage, etc)
are not suggested to be used, especially beverages that include grain must not be used
(may result in blockage and damage).
• Hot water must not be filled into the water tank directly.
• Do not touch other parts of the unit when filling water, it may lead to leakage.
12