Installation; Location; Levelling The Unit; Free Space Requirements - Kenwood K4D496X18 Installation Instructions Manual

installation

location

When selecting a position for your unit you should make sure the floor is flat and firm, and the
room is well ventilated with an average room temperature of between 16°C and 43°C. Avoid
locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight
as it may increase the electrical consumption. Extreme cold ambient temperatures may also
cause the unit not to perform properly. This unit is not designed for use in a garage or outdoor
installation. Do not drape the unit with any covering.

levelling the unit

To do this adjust the two levelling feet at the front of the
unit. If the unit is not level, the doors and magnetic seal
alignments will not be covered properly.
You can also level the unit by inserting the plastic
washers.
1. Raise the lower door slightly.
2. Use a plier to insert the plastic washers in between
the bottom hinge and hinge grommet.

free space requirements

When installing the unit, ensure that 10 cm of free
space is left at both sides, 5 cm at the rear of the
unit and 30 cm at the top of the unit.
Please ensure there is more than twice the width
and depth distance space of the unit to fully open
the doors to a maximum angle.

cleaning before use

Wipe the inside of the unit with a weak solution of bicarbonate soda. Then rinse with warm water
using a sponge or cloth. Wipe completely dry before replacing the drawers. Clean the exterior of
the unit with a damp cloth.
If you require more information refer to the Cleaning section.
• Before Plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the unit.
• Before Turning On!
Do not turn on until two hours after moving the unit. The coolant fluid needs time to
settle.

before using your unit

Before placing any food in your unit, turn it on and wait for 24 hours, to make sure it is working
properly and to allow it time to fall to the correct temperature. Your unit should not be overfilled.
Y mm
X mm
Hinge grommet
Bottom hinge
Y mm
X mm
7