Defining The Configuration Definition File - Hitachi AMS2100 User Manual

% auhgmap -unit array-name -add 0 A 0 6 0
Are you sure you want to add the mapping information?
(y/n [n]): y
The mapping information has been set successfully.
%
% auhgmap -unit array-name -refer
Mapping mode = ON
Port
0A
%

Defining the configuration definition file

C-4
Hitachi AMS 2000 Family Copy-on-Write SnapShot User Guide
•
3. Execute the auhgmap command to verify that the LU Mapping is
set. For example:
•
Group H-LUN LUN
0 6 0
The configuration definition file is a text file created and/or edited
using any standard text editor. It can be defined from the PC where
CCI software is installed. It is required to make CCI operational.
A sample configuration definition file, HORCM_CONF, is included with
the CCI software. It should be used as the basis for creating your
configuration definition file(s). The system administrator should copy
the sample file, set the necessary parameters in the copied file, and
place the copied file in the proper directory. For details on
configuration definition file, refer to the Hitachi Adaptable Modular
Storage Command Control Interface (CCI) User's Guide.
The configuration definition file can be automatically created using
the mkconf command tool. For details on the mkconf command, refer
to the Hitachi Adaptable Modular Storage Command Control
Interface (CCI) Reference Guide. However, the parameters, such as
poll(10ms) must be set manually (see step 4 below).
Example for manually defining the configuration definition
file
The following describes an example for manually defining the
configuration definition file when the system is configured with two
instances within the same Windows host.
The P-VOL and V-VOLs are conceptually diagrammed in the following
figure.
•
Operations using CCI