8.2 Connecting the material edge sensor
Turn off the power switch before connecting the cords, otherwise damage to the control box, synchronizer,
operation panel or material edge sensor may result.
• The sensor II is used for this product.
• Sensor II is used in conjunction with the F-20, F-40 or F-100 operation panel, and cannot be used by itself.
• The sensor II connection method differs according to the operation panel type.
• Built-in type
q
e
t
r
1. Remove the operation panel q from the machine.
2. Insert the sensor II connector e into connector w in the
operation panel.
3. Using a mounting bracket r, screw the sensor II t onto
the machine.
4. Install the operation panel q onto the machine.
20
w
CAUTION
• External type
q
q
1. Remove the operation panel q from the mounting
bracket w.
2. Bend the protrusion e on the right side of the opera-
tion panel.
3. Insert the sensor II connector t into connector r in the
operation panel.
4. Install the sensor II y and operation panel q onto the
mounting bracket w as shown in the illustration.
MD-602, 612
w
e
r
t
w
y