Explanation Of Each Mode; Initialization Mode - Brother MD-602 Service Manual

15. Explanation of each mode

Besides the normal stitching mode, the head setting mode, initialization mode, and memory switch setting mode, etc., can
be entered using the operation panel and various settings can be made. (If the power switch is turned ON while holding
down the designated key, the initialization and head setting modes can be entered. If the designated key is pressed while
the thread trimming needle is stopped at the UP position in the stitching mode, the memory switch setting mode, etc., can
be entered.)
(Note) This function can be used only when the F-40 or F-100 operation panel is connected. This cannot be used with the
F-20 panel. Once the settings are made with the F-40 or F-100 operation panel connected, the set details will be
registered even if the panel is disconnected.
Explanation of flow chart

15.1 Initialization mode

Various data can be registered in the memory on the control PCB, and can be changed as required. If the data is changed
by mistake, the data can be initialized with the initialization mode.
(Note) Only this function can be used with the F-20 panel.
[ ] + Power switch ON
Initialization mode
When [
[ A L ] will display first.
Initialization mode menu
Entire memory initialization
[
Initialization of No. of stitch data
[
Initialization of parameters and
memory switches
[
Initialization of speed data
[
End code
[
36
[ ] ... Indicates the display.
[ ] ... Indicates a key operation.
+ ... Indicates simultaneous double operation.
[i n ]
] is pressed, the display will change to the initialization mode menu.
[ A L ]
] of B
[ S n ]
] of B
[ M P ]
] of B
[ S P ]
] of B
[ E n ]
] of B
Initialize by pressing [
Execute [ S n ]+[ M P ]+[ S P ].
[ C L ] will display when executed.
The display will go out when the stitching mode is entered.
The settings for head setting mode will also be initialized.
Initialize by pressing [
Initialize by pressing [
Initialize to parameters, etc., of head
data set in head setting mode.
Initialize by pressing [
Initialize to speed of head data set in
head setting mode.
Not initialize by pressing [
instead move to stitching mode.
MD-602, 612
].
].
].
].
], and
Stitching mode