Memory Switch Setting Mode And Parameter Setting Mode, Etc - Brother MD-602 Service Manual

15.3 Memory switch setting mode and parameter setting mode, etc.

A memory switch mode for changing the functions and a parameter mode where the time and timing, etc., can be changed
are provided.
Power switch ON
Stitching mode
Setting mode menu 1
Memory switch
setting mode
[ d S ]
[ ] of B
Parameter setting
mode
[ P A ]
[ ] of B
End code
[ E n ]
[ ] of B
38
(Note 1) These settings cannot be made with F (X)-20. Use F (X)-40 or F (X)-100.
(Note 2) To prevent unintentional changes of the parameters, the parameter
setting mode cannot be entered unless the memory switch [ 01 ] is set
to ON.
When the [ ] key is pressed while holding down the [
menu [ d S ] display will appear. <The state where the thread trimming needle is
stopped at the UP position and nothing is displayed for A, B, C and D must be
entered.> <When setting with the F-100, pattern 1 must be entered.>
[ ]
Thread trim-
ming validity
[
Start backtack
double
[
— — —
[
[
(Note 2)
[ ]
Delay time to thread wiper
ON
[
Thread wiper ON time
[
— — —
[
[
After ending the
setting mode
menu 1 by pres-
sing the [
key, the stitching
mode is returned
to.
MD-602, 612
〈〈Memory switch setting mode〉〉
[ 1 1 - o ]
Presser UP after
thread trimming
] of A
[ 2 1 - o ]
] of A
— — —
[ - o ]
] of A
[ E n ]
End code
[ ] of A
]
〈〈Parameter setting mode〉〉
[ t 0 0 2 ]
Setting can be changed with
] of B
[
[ t 1 0 2 ]
] of B
[
] of B
[ E n ]
End code
[ ] of B
]
Display changes to [ S P ] when
[
Setting mode menu 2
Stitching speed setting mode
[
]
Input/output check mode
[
ROM version mode
[
[
] key, the setting
[ o ] : off, [ @ ] : on
[ ] of B
[ 1 2 - o ]
[ ] of B
[ ] of B
] and [ ] of [ CD ].
]
] + [ ] are pressed.
[ S P ]
] of B
[ C P ]
] of B
[ r o ]
] of B
End code [ E n ]
]