Operation - Silvercrest SHTD 2200D A1 Operating Instructions Manual

Operation

NOTICE
► Before using the appliance for the first time, run it at the highest heat and
blower level for approx . 2 minutes (see "Heat and blower levels") . This re-
moves manufacturing residue on the heating elements inside the appliance .
Heat and blower levels
1) Insert the plug into a power socket .
2) Switch the hair dryer on with the blower level switch 5 .
The hair dryer is fitted with two function switches . With these you can separately
select the strength of the air flow (blower level switch 5) and the level of heat
(heat level switch 6):
Blower levels
0
Heat levels
3) After use, switch the appliance off in that you place the blower level switch 5
into position "0" . Then remove the plug from the wall socket .
Cooling level
With the cooling level button 7
combination of blower and heat levels (except level "0") . If you wish to create
a cold air stream, press and hold the cooling level button 7
longer need the cold air stream, release the cooling level button 7
■ 6 │ GB │ IE │ NI
The hair dryer is switched off
reduced air flow
full power air flow
low heating level
medium heat level
high heating level
d
you can produce a cooler air flow with any
d
. When you no
d
.
SHTD 2200D A1