Installing the rack cabinet
For the detail of installation method for the rack cabinet, see Hitachi Compute
Blade 2000/1000/320 and Hitachi Compute Rack 220/210 Site Planning Guide.
For more information about the rack cabinet, see Rack cabinet user's manual
bundled with the rack cabinet.
Installing the system unit
This section describes how to install the system unit in a rack cabinet.
Installing the rack rail
When you mount the system unit to the rack cabinet, use the rack rails provided
for exclusive use with the system unit. Use a Hitachi rack cabinet or an EIA
standard rack.
The following describes the procedure to install the rack rails in a rack cabinet.
1. Slide out the inner rail from outer rail while pressing the button on the inner
rail until the inner rail stops.
Then the inner rail is locked by lock latch (White).
2. Further slide out the inner rail while pulling the lock latch (White) and
disengage the inner rail.
3-2
When you disengage the inner rail while pressing the lock latch
(White), you need to pull the inner rail with a lot of force because
the rail is tight. Be careful to the surroundings and make sure you
do not hit anything.
The rack rails have a distinction of right and left as follows:
•
Left side (towards front of the system unit)
–
Outer rail
Stamp "L" and
arrow.
Right side (towards front of the system unit)
–
Outer rail
Stamp "R" and
arrow.
One step of the outer rail slides.
•
In the whole rack rail, two steps slide including one step of slide
of the inner rail.
Installation
Hitachi Compute Rack 220H Getting Started Guide
Inner rail
Stamp "LEFT".
Inner rail
Stamp "RIGHT".