Chapter 3 Setup
1.
Turning on the Server
Turn on the server by using the following procedure.
1. Turn on the peripheral devices and display unit.
2. Remove Front Bezel.
3. If STATUS LEDs are lighting green or amber, wait until they go off.
4. Press POWER Switch at the front of the server.
POWER LED is turned on green and after a while, logo appears on the display.
While logo is being displayed, the self-diagnostic program (POST) runs and diagnoses the hardware. For
details, see Chapter 3 (1.1 POST).
Tips
Wait for at least 30 seconds before turning on the server after turning it off.
Note
If the power cord is connected to power control system such as an Uninterruptible
Power Supply (UPS), make sure that the power control system is turned on.
Important
Do not connect or disconnect USB device while POST is running.
POWER Switch
Express5800/R120f-1E User's Guide
1. Turning on the Server
113